User`s guide

Chapter 1 1-11
System Verification and Performance Tests
System Verification
6. If you have difficulty with the printer:
a. If the interface on your printer is GPIB, verify that the printer
address is set to 1 (or change the setting in the analyzer to match
that of the printer).
b. If the interface on your printer is serial or parallel, be sure that
you selected the printer port and the printer type correctly (refer
to the standard documentation for more information on how to
perform these tasks).
7. Press System, SERVICE MENU, TESTS, SYS VER TESTS, EXECUTE TEST.
8. The analyzer displays Sys Ver Init DONE. The initialization
procedure is complete.
CAUTION Do not press Preset or recall another instrument state. You must use the
instrument state loaded during the initialization procedure.