User`s guide

Chapter 1 1-43
System Verification and Performance Tests
Performance Tests
5. Connect the equipment as shown in Figure 1-17.
Figure 1-17 Setup for Checking the R Sampler (A4)
6. Repeat the test, but select the B sampler (A6) by pressing Meas,
INPUT PORTS, B
. Use the following specifications:
300 kHz to 3 GHz <− 27 dBm
3 GHz to 6 GHz <− 22 dBm
7. If the analyzer fails the test, replace the A11 assembly.
Verify that the high/low band adjustments are still within
specifications. For more information on how to perform this task,
refer to the “High/Low Band Transition Adjustment” information
located in the standard documentation.
8. Refer to Chapter 3, "Theory of Operation and Troubleshooting‚" for
information regarding specialized troubleshooting for the analyzer.