Specifications

4-54
Hardkey/Softkey Reference
Analyzer Functions
accesses a series of sequencing menus. These allow you to
create, modify, and store up to 6 sequences which can be
run automatically.
activates editing mode for the segment titled "SEQ1"
(default title).
activates editing mode for the segment titled "SEQ2"
(default title).
activates editing mode for the segment titled "SEQ3"
(default title).
activates editing mode for the segment titled "SEQ4"
(default title).
activates editing mode for the segment titled "SEQ5"
(default title).
activates editing mode for the segment titled "SEQ6"
(default title).
accesses a file naming menu which is used to
automatically increment or decrement the name of a file
that is generated by the network analyzer during a
SEQUENCE.
leads to a series of service and test menus described in
detail in the service guide.
a collection of common modes used for troubleshooting.
goes to the address menu, which is used to set the GPIB
address of the analyzer, and to display and modify the
addresses of peripheral devices in the system, such as the
printer, plotter, disk drive, and power meter.
allows you to set the analyzer's internal clock.
allows you to set the day in the analyzer's internal clock.
(Option 010 only) changes the frequency sweep to
harmonic intervals to accommodate time domain low-pass
operation. If this mode is used, the frequencies must be set
before calibration.
allows you to set the hour in the analyzer's internal clock.
allows you to set the minutes in the analyzer's internal
clock.
allows you to set the month in the analyzer's internal
clock.
sets the measurement reference plane to the TRL/LRM
REFLECT standard.
Seq
SEQUENCE 1 SEQ1
SEQUENCE 2 SEQ2
SEQUENCE 3 SEQ3
SEQUENCE 4 SEQ4
SEQUENCE 5 SEQ5
SEQUENCE 6 SEQ6
SEQUENCE FILENAMING
SERVICE MENU
SERVICE MODES
SET ADDRESSES
SET CLOCK
SET DAY
SET FREQ LOW PASS
SET HOUR
SET MINUTES
SET MONTH
SET REF: REFLECT