Specifications

4-55
Hardkey/Softkey Reference
Analyzer Functions
sets the measurement reference plane to the TRL/LRM
THRU standard.
allows you to set the year in the analyzer's internal clock.
sets the characteristic impedance used by the analyzer in
calculating measured impedance with Smith chart
markers and conversion parameters. Characteristic
impedance must be set correctly before calibration
procedures are performed.
sets up four-graticule, four-channel display as described in
the menu. All four graticules are
in log format.
sets up two-graticule, four-channel display as described in
the menu.
sets up single-graticule, four-channel display as described
in the menu.
sets up four-graticule, four-channel display as described in
the menu. Two of the graticules
are in Smith chart format with the other two in log format.
sets up two-graticule, four-channel display as described in
the menu.
sets up three-graticule, three-channel display as described
in the menu.
for cal kits with different models for male and female test
port standards, this selects the short model for a female
test port. Note that the sex of a calibration standard
always refers to the test port.
for cal kits with different models for male and female test
port standards, this selects the short model for a male test
port. Note that the sex of a calibration standard always
refers to the test port.
used to display a specific menu prior to a pause statement
in a sequence.
takes one sweep of data and returns to the hold mode.
sets the limits at a single stimulus point. If limit lines are
on, the upper limit value of a single point limit is
displayed as ∨ and the lower limit is displayed as ∧. A
limit test at a single point not terminating a flat or sloped
line tests the nearest actual measured data point. A single
point limit can be used as a termination for a flat line or
sloping line limit segment. When a single point terminates
SET REF: THRU
SET YEAR
SET Z0
SETUP A
4 PARAM HELP KEYS
SETUP B
4 PARAM HELP KEYS
SETUP C
4 PARAM HELP KEYS
SETUP D
4 PARAM HELP KEYS
SETUP E
4 PARAM HELP KEYS
SETUP F
4 PARAM HELP KEYS
SHORT (F)
SHORT (M)
SHOW MENUS
SINGLE
SINGLE POINT