Specifications

5-11
Error Messages
Error Messages in Alphabetical Order
FUNCTION NOT AVAILABLE
Error Number
202
The function you requested over GPIB is not available on the current
instrument.
FUNCTION NOT VALID
Error Number
14
The function you requested is incompatible with the current instrument state.
FUNCTION NOT VALID DURING MOD SEQUENCE
Error Number
131
You cannot perform sequencing operations while a sequence is being modified.
FUNCTION NOT VALID FOR INTERNAL MEMORY
Error Number
201
The function you selected only works with disk files.
FUNCTION ONLY VALID DURING MOD SEQUENCE
Error Number
163
You can only use the capability when you are building a
sequence. Attempting to use this softkey at any other time returns an error
message and no action is taken.
8753 SOURCE PARAMETERS CHANGED
Error Number
61
Some of the stimulus parameters of the instrument state have been changed,
because you have turned correction on. A calibration set for the current
measurement parameter was found and activated. The instrument state was
updated to match the stimulus parameters of the calibration state. This
message also appears when you have turned on harmonic mode or frequency
offset, and the present frequency range cannot be used with one of these modes.
GPIB COPY IN PROGRESS, ABORT WITH LOCAL
Error Number
169
An GPIB copy was already in progress when you requested the GPIB for
another function. To abort the first copy, press , otherwise the GPIB is
unavailable until the first copy is completed.
IF BW KEY DISABLED, EDIT LIST MODE TBL
Information
Message
When list IF bandwidth has been enabled and swept list mode is on, you will not
be able to change the IF bandwidth using the key. To change the IF
bandwidth, edit the swept list table.
GOSUB SEQUENCE
Local
IF BW