Specifications

6-3

Options and Accessories

Analyzer Options Available

Option 1D5, High Stability Frequency Reference

Option 1D5 offers ±0.05 ppm temperature stability from 0 to 55 °C (referenced to 25 °C),

and aging rate of ±0.5 ppm per year (typical).

Option 002, Harmonic Mode

Provides measurement of second or third harmonics of the test device's fundamental

output signal. Frequency and power sweep are supported in this mode. Harmonic

frequencies can be measured up to the maximum frequency of the receiver. However, the

fundamental frequency may not be lower than 16 MHz.

Option 006, 6 GHz Operation

Option 006 extends the maximum source and receiver frequency of the analyzer to 6 GHz.

This option also allow operation down to 30 kHz.

Option 010, Time Domain

This option displays the time domain response of a network by computing the inverse

Fourier transform of the frequency domain response. It shows the response of a test device

as a function of time or distance. Displaying the reﬂection coefﬁcient of a network versus

time determines the magnitude and location of each discontinuity. Displaying the

transmission coefﬁcient of a network versus time determines the characteristics of

individual transmission paths. Time domain operation retains all accuracy inherent with

the correction that is active in the frequency domain. The time domain capability is useful

for the design and characterization of such devices as SAW ﬁlters, SAW delay lines, RF

cables, and RF antennas.

Option 075, 75 Ω Impedance

Option 075 offers 75 ohm impedance bridges with type-N (f) test port connectors.

Option 1CM, Rack Mount Flange Kit Without Handles

Option 1CM is a rack mount kit containing a pair of ﬂanges and the necessary hardware to

mount the instrument, with handles detached, in an equipment rack with 482.6-mm (19

inches) horizontal spacing.

Option 1CP, Rack Mount Flange Kit With Handles

Option 1CP is a rack mount kit containing a pair of ﬂanges and the necessary hardware to

mount the instrument with handles attached in an equipment rack with 482.6 mm (19

inches) spacing.