Specifications

ManualsBrandsAgilent Technologies ManualsNetwork Router8753ES

151

152

153

154

155

156

157

158

159

160

6-5

Options and Accessories

Accessories Available

For accessories not listed in this section, refer to the conﬁguration guide for your analyzer

or refer to the following Internet site:

www.agilent.com/find/8753

Measurement Accessories

Accessories are available in these connector types: 3.5-mm, 7-mm, 50-ohm type-N, 7-16,

75-ohm type-N, and type-F. A standard 8753ES or one equipped with Option 075 includes

a built-in test set. A calibration kit and test port cables should be added for a complete

measurement system. For an 8753ES Option 011 network analyzer, you also need to add a

test set and power splitter or bridge.

Test port cables are used to connect to the device under test. Calibration kits include

standards, such as open/short circuits and loads, which are measured by the network

analyzer for increased measurement accuracy. Electronic calibration (ECal) modules are

used with the ECal PC interface kit to provide automated calibration (in place of a

calibration kit). A veriﬁcation kit is used to verify system performance.

Test-Port Cables: Type-N

• 11851B 50-ohm type-N RF cable kit

For systems based on an 8753ES Option 011 without the 85946B 75-ohm S-parameter

test set. Includes three phase-matched 61-mm (24-in) cables and one 860-mm (34-in)

cable. Used with the 11850C and 116667A power splitters.

• Part Number 8120-5639 50-ohm type-N (m) to type-N (m) cable RF cable

For use with the 8753ET.

Calibration Kits

Choose a kit for each connector type to be used.

• 85031B 50-ohm 7-mm calibration kit

Contains ﬁxed loads, open and short circuits.

• 85032B 3.5 50-ohm type-N calibration kit

Contains ﬁxed loads, open and short circuits, TRL lines, and adapters for both

connector sexes for use with7-mm test-port cables.

— Option 001

Deletes 7- mm to type-N adapters.

• 85033D 50-ohm 3.5-mm calibration kit

Contains ﬁxed loads, one-piece open and short circuits, and 7-mm to 3.5-mm adapters

for both connector sexes for use with 7-mm test-port cables.

— Option 001

Deletes 7-mm to 3.5-mm adapters.