Specifications

4-11
Hardkey/Softkey Reference
Analyzer Functions
brings up the segment modify menu and segment edit
(calibration factor menu) which allows you to enter a
power sensor's calibration factors. The calibration factor
data entered in this menu will be stored for power sensor
A.
sets the preset state of interpolated error-correction on or
off.
brings up the segment modify menu and segment edit
(calibration factor menu) which allows you to enter a
power sensor's calibration factors. The calibration factor
data entered in this menu will be stored for power sensor
B.
indicates the currently selected cal kit and leads to the
select cal kit menu, which is used to select one of the
default calibration kits available for different connector
types. This, in turn, leads to additional menus used to
define calibration standards other than those in the
default kits (refer to “Modifying Calibration Kits” in the
“Operating Concepts” chapter of the user’s guide). When a
calibration kit has been specified, its connector type is
displayed in brackets in the softkey label. The cal kits
available are listed below, refer to the softkey descriptions
for these softkeys for more information.
—
—
—
—
—
—
—
this default selection establishes the TRL/LRM
LINE/MATCH standard as the characteristic impedance.
allows you to modify the characteristic impedance of the
system for TRL/LRM calibration.
leads to the calibration menu, which provides several
accuracy enhancement procedures ranging from a simple
frequency response calibration to a full two-port
calibration. At the completion of a calibration procedure,
this menu is returned to the screen, correction is
automatically turned on, and the notation Cor or C2 is
displayed at the left of the screen.
CAL FACTOR SENSOR A
CAL INTERP ON off
CAL FACTOR SENSOR B
CAL KIT [ ]
2.4 mm 85056
2.92* 85056K
2.92 mm other kits
3.5 mm C 85033C
7-16 85038
N 75
Ω
85036
TRL 3.5 mm 85052C
CAL ZO: LINE ZO
CAL ZO: SYSTEM ZO
CALIBRATE MENU