Specifications

4-14
Hardkey/Softkey Reference
Analyzer Functions
clears a sequence from memory. The titles of cleared
sequences will remain in load, store, and purge menus.
This is done as a convenience for those who often reuse the
same titles.
defines the standard (and the offset) as coaxial. This
causes the analyzer to assume linear phase response in
any offsets.
applies a linear phase compensation to the trace for use
with electrical delay. That is, the effect is the same as if a
corresponding length of perfect vacuum dielectric coaxial
transmission line was added to the reference signal path.
adjusts the degree of whiteness of the color being modified.
Refer to the section on adjusting the display color in the
“Using Measurement Functions” chapter of the user’s
guide for an explanation of using this softkey for color
modification of display attributes.
provides access to the configure ext disk menu. This menu
contains softkeys used to the disk address, unit number,
and volume number.
provides access to the configure menu. This menu contains
softkeys used to control raw offsets, spur avoidance, the
test set transfer switch, and user preset settings.
resumes a paused sequence.
located under the key, is the standard
sweep mode of the analyzer, in which the sweep is
triggered automatically and continuously and the trace is
updated with each sweep.
brings up the conversion menu which converts the
measured data to impedance (Z) or admittance (Y). When
a conversion parameter has been defined, it is shown in
brackets under the softkey label. If no conversion has been
defined, the softkey label reads .
provides access to the menus used for controlling external
plotters and printers and defining the plot parameters.
turns error correction on or off. The analyzer uses the most
recent calibration data for the displayed parameter. If the
stimulus state has been changed since calibration, the
original state is recalled, and the message "SOURCE
PARAMETERS CHANGED" is displayed.
switches the counter to count the analog bus.
switches the counter to count the A14 fractional-N VCO
frequency after it has been divided down to 100 kHz for
CLEAR SEQUENCE
COAX
COAXIAL DELAY
COLOR
CONFIGURE EXT DISK
CONFIGURE MENU
CONTINUE SEQUENCE
CONTINUOUS
Sweep Setup
CONVERSION [ ]
CONVERSION [OFF]
Copy
CORRECTION on OFF
COUNTER: ANALOG BUS
COUNTER: DIV FRAC N