Technical data

1-6 Chapter 1

Service Equipment and Analyzer Options

Analyzer Options Available

Option 1D5, High Stability Frequency Reference

This option offers ±0.05 ppm temperature stability from 0 to 60 °C (referenced to 25 °C).

Option 002, Harmonic Mode

This option provides measurement of second or third harmonics of the test device's

fundamental output signal. Frequency and power sweep are supported in this mode.

Harmonic frequencies can be measured up to the maximum frequency of the receiver.

However, the fundamental frequency may not be lower than 16 MHz.

Option 006, 6 GHz Operation

This option extends the maximum source and receiver frequency of the analyzer to 6 GHz.

Option 010, Time Domain

This option displays the time domain response of a network by computing the inverse

Fourier transform of the frequency domain response. It shows the response of a test device

as a function of time or distance. Displaying the reflection coefficient of a network versus

time determines the magnitude and location of each discontinuity. Displaying the

transmission coefficient of a network versus time determines the characteristics of

individual transmission paths. Time domain operation retains all accuracy inherent with

the correction that is active in of such devices as SAW filters, SAW delay lines, RF cables,

and RF antennas.

Option 1CM, Rack Mount Flange Kit without Handles

This option is a rack mount kit containing a pair of flanges and the necessary hardware to

mount the instrument, with handles detached, in an equipment rack with 482.6 mm

(19 inches) horizontal spacing.

Option 1CP, Rack Mount Flange Kit with Handles

This option ia a rack mount kit containing a pair of flanges and the necessary hardware to

mount the instrument with handles attached in an equipment rack with 482.6 mm

(19 inches) spacing.