User`s guide

1-105
Making Measurements
Using Test Sequencing
Start of Sequence
RECALL PRST STATE
Trans: FWD S21 (B/R)
LOG MAG
CENTER
134 M/u
SPAN
50 M/u
SCALE/DIV
AUTO SCALE
3. To change a command (for example, the span value from 50 MHz to 75 MHz), move the
cursor (→) next to the command that you wish to modify, press:
or
• If you use the key to move the cursor through the list of commands, the
commands are actually performed when the cursor points to them. This feature
allows the sequence to be tested one command at a time.
• If you wish to scroll through the sequence without executing each line as you do so,
you can press the key and scroll through the command list backwards.
4. To delete the current command (for example, span value), press:
5. To insert a new value (for example, 75 MHz), press:
6. Press to exit the modify (edit) mode.
Clearing a Sequence from Memory
1. To enter the menu where you can clear a sequence from memory, press:
2. To clear a sequence, press the softkey of the particular sequence.
Changing the Sequence Title
If you are storing sequences on a disk, you should replace the default titles (SEQ1,
SEQ2, …).
1. To select a sequence that you want to retitle, press:
and select the particular sequence softkey.
The analyzer shows the available title characters. The current title is displayed in the
upper-left corner of the screen.
2. You can create a new file name in two ways:
• If you have an attached DIN keyboard, you can press the f6 function key on the
keyboard and type the new file name.
75 M/µ
Seq
DONE SEQ MODIFY
Seq
MORE
CLEAR SEQUENCE
Seq
MORE
TITLE SEQUENCE