User`s guide

4-9

Printing, Plotting, and Saving Measurement Results

Configuring a Plot Function

All copy configuration settings are stored in non-volatile memory. Therefore, they are not

affected if you press or switch off the analyzer power.

Peripheral Interface Recommended Cables

Parallel 92284A

GPIB 10833A/33B/33D

Serial 24542G

1. Connect the peripheral to the interface port using the recommended cable from the

following list.

Figure 4-3 Peripheral Connections to the Analyzer

If You Are Plotting to an HPGL/2 Compatible Printer

2. Press and then press until

HPGL PRT appears.

Information regarding a printer compatibility guide (an up-to-date list of printers that

are compatible with the network analyzer) is available in "Printing or Plotting Your

Measurement Results" on page 4-3.

3. Configure the analyzer for one of the following printer interfaces:

• Choose if your printer has an GPIB interface, and then

configure the print function as follows:

a. Enter the GPIB address of the printer (default is 01), followed by .

b. Press and if there is no external controller

connected to the GPIB bus.

c. Press and if there is an external controller

connected to the GPIB bus.

Preset

Local

SET ADDRESSES

PLTR PORT

PLTR TYPE [ ]

PRNTR PORT GPIB

Local

SYSTEM CONTROLLER

Local

USE PASS CONTROL