Installation guide

Setting up a LAN Instrument Network 17
Figure 6: Telnet command
where <IP address> is a nonroutable unique local address that you
assign or a routable address assigned by the site LAN manager.
When the connection was established successfully, the card
responds with the following:
Figure 7: Telnet result
3. To set the IP address, subnet mask, and gateway enter the
command <ipaddress> for each instrument. The value of the
command is shown in the table below.
For example: ip 134.40.24.230
Press [Enter] after each command.
Table 3: Telnet Commands
Command Description
? Displays syntax and descriptions of commands
/ Displays current settings
ip <address> Sets new ip address
sn <address> Sets new subnet mask
gw <address> Sets new default gateway
Quit Saves changes and exit shell
Exit Exits shell without saving changes
4. Use the “/” and press Enter to list the current settings.