User`s guide

 Connect the E5810A to the Network and to Instruments. This figure shows
typical network and instrument connections for the E5810A. Make connections as
required for your application. See the E5810A LAN/GPIB Gateway for Windows
User's Guide for detailed connections.
IMPORTANT
BEFORE making any Enterprise (corporate) network connections, contact your
Information Technology (IT) department for policies concerning user connections, IP
addresses, etc. See Contacting Your IT Department on the back of this poster for
suggested actions.
 Apply Power to the E5810A. Plug the E5810A power cord into the E5810A POWER
socket. Then, plug the cord into an AC outlet and observe the E5810A display. After
an initial setup period, the E5810A IP address and hostname (if recognized) should
appear on the display. If the IP address does not appear, see Troubleshooting
Information on the back of this poster.
LAN
Tx
Ln
GP IB
RS232
!
POWER
GPIB
GPIB
GPIB
GPIB Instruments
Typically Hub or
Switch
OR
To Enterprise
Network Instrument
To RS-232
To AC Power
GPIB
LAN
E5810A
2 Install the E5810A