User`s guide

Connecting Instruments to LAN

Step 5: Configure Your Instruments

What’s in This Step? This may be an optional step. This step shows how to manually set

TCP/IP parameters for LAN-enabled instruments, using the instrument’s

Web Pages.

# If your LAN supports DHCP and you selected automatic

configuration for your instruments,

skip this step and go to

Step 6: Configure the LAN Interface

# If the LAN does not support DHCP or you want to make

configuration changes, you can use the steps in this section

to configure your instruments. Then, go to Step 6: Configure

the LAN Interface.

As required, manually configure your instruments using the instrument's

Web Pages or front panel.

5 Configure Your Instruments

You can use the Configuring

Your Instrument

Web Page to

configure instruments.