User manual

24 G1369B LAN Interface User Manual
2Getting Started
LAN Interface Configuration
Using Stored
When initialization mode “Using Stored” is selected, the parameters are taken
from the non-volatile memory of the card. The TCP/IP connection will be
established using these parameters. The parameters were configured
previously by one of the described methods.
Figure 13 Using Stored (Principle)
Using Default
When “Using Default” is selected, the factory default parameters are taken
instead. These parameters enable a TCP/IP connection to the LAN Interface
without further configuration, see Table 6.
Figure 14 Using Default (Principle)
Active
Parameter
Non-Volatile
RAM
Stored
Parameter
Default
Parameter
Active
Parameter
NOTE
Using the default address in your local area network may result in network problems. Take
care and change it to a valid address immediately.
Table 6 Using Default Parameters
IP address: 192.168.254.11
Subnet Mask: 255.255.255.0
Default Gateway not specified