User's Manual

74 Chapter 1
GPIB Command Dictionary
AFG2|ENCoder subsystem
:SEND
This command sends the encoder data stream.
Syntax
AFG2:SEND
Screen/field equivalent
AFG2:SEND controls the Send field on the SIGNALING ENCODER
screen when the Mode field is set to AMPS-TACS, NAMP-NTAC, or DTMF.
:STOP
This command stops the data stream that is being output when
AFG2:SEND:MODE is ‘Cont’ or ‘Burst’.
Syntax
AFG2:STOP
Screen/field equivalent
AFG2:STOP controls the Stop field on the SIGNALING ENCODER
screen when the Mode field is set to AMPS-TACS, NAMP-NTAC, or DTMF.