User's Manual
Table Of Contents
- Title Page
- Table of Contents
- Documentation Overview
- 1 Safety Information
- 2 Getting Started
- Checking the Shipment
- Signal Generator Physical Characteristics
- Meeting Environmental and Electrical Requirements
- Configuring the MXG ATE
- Configuring the Display (N5181A/82A/83A Only)
- Configuring for Remote Control
- Ordering Accessories
- Proper Use and Cleaning
- Returning a Signal Generator to Agilent Technologies
- Contacting Agilent
- 3 Operation Verification
- 4 Regulatory Information
- Index
10 Agilent N5161A/62A/81A/82A/83A MXG Signal Generators Installation Guide
Getting Started
Configuring for Remote Control
Configuring for Remote Control
1
LAN Configuration
Configuring the LAN Interface
1
For the N5161A/62A these softkey menus and features are only available through the Web- Enabled
MXG ATE or through SCPI commands. Refer to “Configuring the MXG ATE” on page 7, to the Programming
Guide, and to the SCPI Command Reference.
NOTES
Use a 100Base-T LAN cable to connect
the signal generator to the LAN.
Use a crossover cable to connect the
signal generator directly to a PC.
For details on using the instrument
remotely, see the Programming Guide.
Listed in the
Programming Guide
For details on a key, press Help and then the desired key.