Troubleshooting guide

Lab Exercise: Quantification
Setting up Signal Details
93
Setting up Signal Details
The Signal Details dialog box describes which signals will be evaluated during a
method run. Signals that are not in the list box will not be integrated or reported
if all defined signals can be found in the current data file. Whenever the defined
signals cannot be found the system loads all available signals from the data file
and tries to generate the report.
1) From the Calibration menu, select Signal Details…. You may also access
the Signal Details dialog box by first selecting the Calibration Task tool, then
the Edit current method signals tool.
2) Pull down the Available Signals and select DAD1A, Sig=250, 100
Ref=360,100. Now select the Add to Method button. Repeat with signal B.
OK this dialog box.
3) Resave the method.