Troubleshooting guide

Lab Exercise: Sequence Review and Reprocessing
Reprocess with DA Methods
117
Reprocess with DA Methods
In this section, you will see how to change the individual DA methods. You will
add manual integration events to two runs and reprocess.
1) Go to the View menu, then Preferences… >Signal Options.
2) Make certain that Integrate after load is selected under Load Signal
Options and Individual Method from Data File is selected under Method
used for Review of Sequence Data. OK the dialog box.
Note that this can also be specified directly from the user interface at the top of
the Navigation Table. If you change which method is used via this interface, does
it take effect immediately?__________________ Is this method choice used for
data review or reprocessing?_____________________________
3) Find the Data folder 03-15-06 and expand. Double-click on the sequence,
Chem32\1\Data\03-15-06\ClassSequence 2006-03-15 10-46-09 to load .