Troubleshooting guide

Lab Exercise: Sequence Review and Reprocessing
Batch Review
121
Batch Review
If you generate a large number of samples on a daily basis and would like a
convenient way to view the results and check the quality of integration then Batch
Review may help. Batch Review allows you to step through calibration
standards, control samples, and unknown samples adjusting the integration
parameters and reviewing the results of sequence runs.
1) In the Data Analysis view, select Demo\Batch. Find the .b batch file
created during the sequence and load demo\batch.b. Every sequence
creates a .b batch file.
2) Process the data using Batch.M. You would typically process the batch data
using the sequence container method.
3) Select all runs for batch processing. OK the dialog box.
4) Examine the integration for the first data file. If you would like to view a
new data file every 10 seconds, press Start.
5) If you want to change the integration events, then Pause the batch review.
6) Try changing the slope sensitivity on one of the data files and reintegrating.
7) Use the Marked changes to current run for save with batch file tool to mark
those changes you would like to keep. If you do not want to keep an
integration change, select the discard tool.
Note the following additional features before leaving the batch review:
Update the calibration table from all calibrated batch runs
Batch Preview and Batch Report (found under the batch menu), and
Saving the batch.