Troubleshooting guide

Lab Exercise: Commands
Tracking Errors and Using some Common Commands
144
Tracking Errors and Using some Common
Commands
A window can be displayed which will help you track software errors while your
are using commands or writing/using macros. The window is accessed with the
ListMessages command.
1) On the command line, type ListMessages On. Notice that a white message
box is now displayed. The box can be sized differently by dragging the edges.
Cryptic explanations regarding syntax or other errors will be displayed here as
they occur.
2) Type the following sequence of commands onto the command line. After
each command line, you may either use the Enter key or use the semicolon,;,
and the Enter key at the very end of the list. Note the message display.
Delreg chromreg
Loadsignal dad,b,,chromreg
IntegrateObj chromreg[1]
Draw 2,chromreg,6:8
3) Move back through the previous commands by using the up and down arrow
keys. These keys are useful if a typing error has been made and you don't
want to type the entire command over again.