Technical data

Agilent B2900 SCPI Command Reference, Edition 2 4- 93
Subsystem Commands
[:SOURce]:<CURRent|VOLTage>[:LEVel]:TRIGgered[:AMPLitude]
Syntax [:SOURce[c]]:<CURRent|VOLTage>[:LEVel][:IMMediate][:AMPLitude] level
[:SOURce[c]]:<CURRent|VOLTage>[:LEVel][:IMMediate][:AMPLitude]? [level]
For <CURRent|VOLTage>, specify CURRent for current output, or VOLTage for
voltage output.
Parameter level Current or voltage output level. value (see “Source Output
Ranges” on page 2-24) |MINimum|MAXimum|DEFault
(default is 0). Parameter data type is NRf+. Query does not
support level=value.
Query response level <newline>
level returns the present setting. If a parameter is specified, level returns the value
assigned to DEF, MIN, or MAX. Response data type is NR3.
Example :VOLT 3
:SOUR2:CURR:LEV:IMM:AMPL?
[:SOURce]:<CURRent|VOLTage>[:LEVel]:TRIGgered[
:AMPLitude]
Changes the output level of the specified source channel immediately by receiving a
trigger source set by the
:TRIGger<:ACQuire|:TRANsient|[:ALL]>:SOURce[:SIGNal] command.
Syntax [:SOURce[c]]:<CURRent|VOLTage>[:LEVel]:TRIGgered[:AMPLitude] level
[:SOURce[c]]:<CURRent|VOLTage>[:LEVel]:TRIGgered[:AMPLitude]? [level]
For <CURRent|VOLTage>, specify CURRent for current output, or VOLTage for
voltage output.
Parameter level Current or voltage output level. value (see “Source Output
Ranges” on page 2-24) |MINimum|MAXimum|DEFault
(default is 0). Parameter data type is NRf+. Query does not
support level=value.
Query response level <newline>
level returns the present setting. If a parameter is specified, level returns the value
assigned to DEF, MIN, or MAX. Response data type is NR3.