Technical data

5- 10 Agilent B2900 SCPI Command Reference, Edition 2

Error Messages

Device-Dependent Error

-3XX errors indicate that Agilent B2900 has detected an error that is not a

command error, a query error, or an execution error; some device operations did not

properly complete, possibly due to an abnormal hardware or firmware condition.

These codes are also used for self-test response errors.

Error -300 Device-specific error

Generic device-dependent error for B2900 that cannot be determined more

specifically.

Error -310 System error

Some error, termed “system error” by B2900, has occurred.

Error -311 Memory error

An error was detected in B2900’s memory.

Error -313 Calibration memory lost; Calibration data has been lost,

Calibration data is initialized; Channel n

Calibration memory lost; Nonvolatile data saved by the

*CAL? command has been lost; Channel n

Non-volatile data related to the *CAL? command has been lost.

Error -315 Configuration memory lost

Non-volatile configuration data saved by B2900 has been lost.

Error -321 Out of memory

Too many data was sent at a time.

Error -350 Queue overflow

This code is entered into the queue instead of the code that caused the error. This

code indicates that there is no room in the queue and an error occurred but was not

recorded.