Specifications

54
dataTec ▪ Ferdinand-Lassalle-Str. 52 ▪ 72770 Reutlingen ▪ Tel. 07121 / 51 50 50 ▪ Fax 07121 / 51 50 10 ▪ [e-mail] ▪ www.datatec.de
16339A Component Test Fixture
Terminal Connector:
* InterlockConnectorenablesanddisables
the application of source voltage from the
measurement instrument.
DUT Connection: 2-Terminal (with triaxial cable)
Dimensions (approx.): 200(W) x 140(H) x 230 (D) [mm]
Cable Length (approx.): 0.8 m
Weight (approx.): 2200 g
54
DC (High resistance) SMD & Lead Components
Description: The 16339A is designed to operate specifically with
4339B. It is provided with three component modules, which are used
to hold SMD, lead and various type of devices. Electrical noise
effects are reduced by the employment of a shielded case. A built-in
interlocking circuit enables safe high-voltage measurements.
Applicable Instruments: 4339B*
*denotestheinstrumentisobsolete.
Frequency: DC
Maximum Voltage: 1000 V
Maximum Current: 10 mA
Resistance Measurement Range: 1 x 10
3
to 2 x 10
16

Operating Temperature: 0°C to 55°C
DUT Size: For Alligator Clip and Flat Table, lead diameter ≤5 mm
Furnished Accessories:
Compensation and Measurement: Open compensation is recom-
mended before measurement. When using the axial lead module,
have no DUT connected to the electrodes. When using the SMD
module, separate the high and low electrodes from each other. The
separation should be equivalent in size to the DUT’s width. When
using the alligator clip and flat table, remove the alligator clips from
the input terminals of the test fixture. After preparing the open con-
dition of the respective module, close the top cover and then per-
form open compensation. Finally, the DUT is inserted into the
respective module. The following figure shows the three component
modules.
4339B with 16339A
SMD module
Component module configurations
SMD module Axial Lead module Alligator clip and Flat table
DUT Dimensions
Type Connector
Input Triaxial (special screw-type)
Output High Voltage BNC (special type)
Control Interlockconnector*
Description P/N Qty.
Axial Lead Module 16339-60102 1
SMD Module 16339-60101 1
Flat Table 16339-6004 1
Miniature Banana-Plug cable 16339-61621 2
100 kΩ Output Resistor 16339-61001 1
1 MΩ Output Resistor 16339-61002 1
10 MΩ Output Resistor 16339-61003 1
100 MΩ Output Resistor 16339-61004 1
Alligator Clip 8710-1984 2
Carrying Case 16339-600201 1
Operation and Service Manual 16339-90010 1