Technical data

144 U7232A DisplayPort Compliance Testing Notes
14 Calibrating the Infiniium Oscilloscope and Probe
2 Referring to Figure 61 below, perform the following steps:
a Click the Add Head... button, and then select N5380A:DF SMA from
the list of Head Type. Select OK to close the dialog box.
b Click on the Calibrate Probe button to open the Probe Calibration
window.
3 Referring to Figure 62 below, perform the following steps:
a Select the Calibrated Atten/Offset Radio Button
b Click the Start Atten/Offset Calibration Button to open the
Calibration window.
Figure 61 Probe Setup Window.