User`s guide

248
Logic Analyzer Reference
Probing
Probing
This section discusses the probing system for the logic analyzer. It also
contains the information you need for connecting the probe system
components to each other, to the logic analyzer, to the oscilloscope, to
the pattern generator, and to the system under test.
Probing Options
You can connect the logic analyzer to your system under test in one of
the following ways:
• Microprocessor- and bus-specific interfaces (optional).
• Standard general-purpose probing (provided).
• Direct connection to a 20-pin, 3M-Series type header connector using the
optional termination adapter.
See Also
Accessories for Agilent Logic Analyzers for additional information
about the microprocessor interface kits and for any new probing
solutions.