User`s guide

356
System Performance Analysis (SPA) Software
System Performance Analysis Software
Setting up the State Format specification
When a State or Timing analyzer is changed to SPA, SPA will retain the
State or Timing Format specification. For complete details on changing
from a State or Timing Analyzer to SPA, see "Using SPA with other
features."
The State and Timing format specification menus provide symbol
tables. You can use any defined symbols to specify the Low and High
values in State Overview to define the ranges and the qualified states in
State Histogram, or to specify the Start and End conditions in Time
Interval.
Your ability to use existing State or Timing configurations with SPA
depends on your application and target system. If your SPA
measurement uses the same physical signals from the target system as
an existing State or Timing configuration, it may be easier to load the
state or timing configuration from the disk instead of entering a new
one.
This manual assumes you already have a basic understanding of the
Analyzer Format menu, and it will not be covered here.
Default SPA Menu