User`s guide

518

Retrieving and Restoring Data Using the LAN

To restore configurations

1 Access the logic analyzer's file system as the control user.

Refer to the chapter "Accessing the Logic Analyzer File System".

2 Copy the setup.raw file to the appropriate directory.

For system configurations, this would be the \system directory. For

analyzer configurations, this would be the \slot_a directory. For

oscilloscope configurations, it would be the \slot_b directory. If you

copy a configuration file to a different directory than it came from, the

analyzer will not know how to interpret it.

Example Restoring an analyzer configuration

Suppose you want to load a configuration file called "486_bus" from

your local computer into the logic analyzer's analyzer. The analyzer is

always in slot A. The logic analyzer is mounted on your network as disk

drive L:.

To load the configuration file, at the MS-DOS prompt enter:

copy 486_bus L:\slot_a\setup.raw

If your computer is running the UNIX operating system, you might use

the cp command. In an MSWindows environment, you can use File

Manager.