User`s guide

56
Using the Logic Analyzer
Using the Analyzer Menus
5 If additional Symbols are needed, repeat step 4 until you have
added all symbols.
In this example, three symbols are added: MEM RD, MEM WR, and
DATA RD.
6 Toggle the Type field to "range" or "pattern".
When Type is range, a third field appears under the Stop column. To
fully specify a range, you need to enter a value for it, too.
7 Select the Pattern/Start field and use the keypad to enter an
appropriate value in the selected base. Use X for "don't care."
8 When the pattern is specified, press Done. If you created
additional Symbols, repeat steps 6 and 7 until all symbols are
specified.
9 To close the symbol table menu, select Done.
Symbol table Menu Showing Three Symbols
You can also download symbol tables created by your programming
environment using the Symbol Utility. The Symbol Utility is shipped
installed on all 1670G-series logic analyzers.
See Also The Symbol Utility section of this book on page 563 for more
information on the Symbol Utility.