User`s guide

Using the Logic Analyzer

Using the Analyzer Menus

To examine an analyzer listing

The Analyzer Listing menu displays state or timing data as patterns

(states). The Listing menu uses any of several formats to display the

data such as binary, ASCII, or symbols. If you are using an inverse

assembler and select Invasm, the data is displayed in mnemonics that

closely resemble the microprocessor source code.

See Also "The Inverse Assembler" at the end of this chapter for additional

information on using an inverse assembler.

1 In Analyzer mode, press the Run key to acquire data.

In any mode other than Analyzer, Scope, or Patt Gen, pressing the Run

key has no effect. The menus which ignore Run lack the Run field

onscreen. In Analyzer mode with Run available, the menu changes to a

display menu.

2 Go to the Analyzer Listing menu.

All labels defined in the Analyzer Format menu appear in the listing. If

there are more labels than will fit on the screen, the Label/Base field is

shaded like a normal field.

3 To scroll the labels, select the Label/Base field and use the knob

or press the blue shift key and a page key.

If the Label/Base field is selectable, the roll indicator appears over the

field as in the example. To move the labels one full screen at a time,

press Shift and a Page key.