User`s guide

67
Using the Logic Analyzer
The Inverse Assembler
If you roll the trace list to a new position and press Invasm again, the
inverse assembler repeats the above process. However, it does not
work backward in the trace list from the starting position. This may
cause differences in the trace list above and below the point where you
synchronized inverse assembly. The best way to ensure correct inverse
assembly is to synchronize using the first state you know to be the first
byte of an opcode fetch.
See Also The Analysis Probe User's Guide for more information on controlling
inverse assembly. If you have problems using the inverse assembler, see
"Troubleshooting the Logic Analyzer" on page 421.