User`s manual

[SENSe:]
The [SENSe:] command subsystem is most commonly used with CONFigure to
change specific "low-level" measurement parameters. Normally when you execute
CONFigure, the multimeter operates using predefined settings. [SENSe:] enables
you to change the following measurement parameters without completely
reconfiguring the multimeter:
Function
Range
Resolution
Aperture and Integration Time
Autozero
Offset Compensation
Subsystem Syntax [SENSe:]
FUNCtion[:<function>]
FUNCtion?
RESistance
:APERture <time>
:APERture? [MIN | MAX]
:NPLC <number>
:NPLC? [MIN | MAX]
:OCOMpensated <mode>
:OCOMpensated?
:RANGe:AUTO <mode>
:RANGe:AUTO?
:RANGe <range>
:RANGe? [MIN | MAX]
:RESolution <resolution>
:RESolution? [MIN | MAX]
VOLTage
:AC:RANGe <range>
:AC:RANGe? [MIN | MAX]
:APERture <time>
:APERture? [MIN | MAX]
[:DC]:RANGe <range>
[:DC]:RANGe? [MIN | MAX]
:NPLC <number>
:NPLC? [MIN | MAX]
:RANGe:AUTO <mode>
:RANGe:AUTO?
161 Command Reference Chapter 5