User`s manual

Example Changing the Resolution
CONF:FRES 1560,MAX,(@100:103) !Function: 4-wire ohms;
range selected: 1861
Ω
;
MAX resolution: 125 m
Ω
;
specify sense channel list.
RES:RANG 220
!Range selected: 256
Ω
;
MAX resolution: 15.626 m
Ω
.
RES:RES 2.44E-04
!Set resolution to 244
µΩ
;
selects 16.7 ms aperture time
(60 Hz line frequency).
READ? !Place multimeter in wait-for-trigger state and
make measurements;
send readings to output buffer.
enter statement !Enter readings into computer.
RESistance:RESolution?
[SENSe:]RESistance:RESolution? [MIN | MAX] returns one of the following
numbers to the output buffer.
The present resolution selected if
MIN or MAX are not specified. Only the resolution
values available on ranges set by the
RANGe command are returned.
The resolution with the smallest value (the best resolution) for the selected range if
MIN is specified.
The resolution with the largest value (the worst resolution) for the selected range if
MAX is specified.
Example Querying the Resolution
RES:RES 2.44E-04
!Set resolution to 244
µΩ
.
RES:RES? !Query multimeter to return the present
resolution.
enter statement !Enter value into computer.
VOLTage:AC:RANGe
[SENSe:]VOLTage:AC:RANGe <range> selects the range for AC-coupled RMS
voltage measurements.
Parameters
Parameter Name Parameter Type Range of Values Default Units
<range>
numeric 0.0875 V | 0.7 V | 5.6 V | 44.8 V |
300 V | MIN | MAX
volts
Comments • To select a standard measurement range, specify range as the input signal’s
maximum expected voltage. The multimeter then selects the correct range.
169 Command Reference Chapter 5