User`s manual

IEEE 488.2 Common Command Reference
The following table lists the IEEE 488.2 Common (*) Commands that can be
executed by the HP E1326B and HP E1411B 5
1
⁄
2
-Digit Multimeters.
Category Command Title Description
System Data *IDN? Identification Returns the identification string of multimeter.
Internal
Operations
*RST Reset Resets the multimeter and associated multiplexers to:
FUNC:VOLT:DC
VOLT:RANG 8 V
RES:RANG 16384
Ω
RANGE:AUTO ON
VOLT:RES 7.629 µV
RES:RES 15.6 m
Ω
APER 16.7 ms | 20 ms
NPLC 1
RES:COMP OFF
CAL:ZERO:AUTO ON
TRIG:COUN 1
TRIG:DELAY:AUTO ON
TRIG:SOUR IMM
SAMP:COUN 1
SAMP:SOUR IMM
SAMP:TIM 200 µs
*TST? Self-Test Should return 0. If code 1, 2, 3, or 4 occurs, return
multimeter to Hewlett-Packard for repair.
Synchronization
*OPC Operation Complete Operation complete command
*OPC? Operation Complete Query Operation complete query
*WAI Wait to Complete Wait-to-continue command
Status & Event *CLS Clear Status Clear status command
*ESE Event Status Enable Standard event status enable command
*ESE? Event Status Enable Query Standard event status enable query
*ESR? Event Status Register Query Standard event status register query
*SRE Service Request Enable Service request enable command
*SRE? Service Request Enable Query Service request enable query
*STB? Read Status Byte Query Read status byte query
Bus
Operation
*TRG Bus Trigger When the multimeter is in the wait-for-trigger state and the
trigger source is TRIGger:SOURce BUS, use *TRG to
trigger the multimeter.
Instrument *RCL Recall Instrument State Recall instrument state command
*SAV Store Instrument State Store (save) instrument state command
Macros *DMC Define Macro Define macro command
*EMC Enable Macro Enable macro command
*EMC? Enable Macro Query Enable macro query
*GMC? Get Macro Contents Query Get macro contents query
*LMC? Learn Macro Query Learn macro query
*PMC Purge Macros Purge all macros command
*RMC Remove Individual Macro Remove individual macro command
NOTE: These commands apply to many instruments and are not documented here in detail. See your
command module or controller manual, and the ANSI/IEEE Standard 488.2-1987 for more information.
Chapter 5 Command Reference 186