User`s manual

Command Quick Reference
The following tables summarize SCPI commands for the HP E1326B and
HP E1411B 5
1
⁄
2
-Digit Multimeters.
Command Description
ABORt Place multimeter in idle state.
CALibration :LFRequency 50 | 60 | MIN | MAX
:LFRequency? [MIN | MAX]
:ZERO:AUTO OFF | 0 | ON | 1
:ZERO:AUTO?
Change line reference frequency.
Query line reference frequency.
Enable/disable autozero mode.
Query autozero mode.
CONFigure :FRESistance [<range>[,<resolution>]] [,<channel_list>]
:RESistance [<range>[,<resolution>]] , <channel_list>
:TEMPerature <transducer>,<type>,<channel_list>
:VOLTage:AC [<range> [,<resolution>]] [,<channel_list>]
:VOLTage[:DC] [<range> [,<resolution>]] [,<channel_list>]
Configure multimeter for 4-wire ohms.
Configure multimeter for 2-wire ohms.
Configure multimeter for temperature.
Configure multimeter for AC voltage.
Configure multimeter for DC voltage.
CONFigure? Query multimeter configuration.
DIAGnostic :FETS <mode>
:FETS?
Selects control of FET multiplexers.
Query mode of operation.
DISPlay :MONitor:CHANnel <channel> | AUTO
:MONitor:CHANnel?
:MONitor[:STATe] OFF | 0 | ON | 1
:MONitor[:STATe]?
Monitor multiplexer channel.
Query monitor channel.
Enable/disable monitor mode.
Query monitor mode.
FETCh? Place stored readings in output buffer.
FORMat [:DATA] <type>[,<length>] Select output data format and length.
FORMat? Query format.
INITiate [:IMMediate] Place multimeter in wait-for trigger state.
MEASure :FRESistance? [<range>[,<resolution>]] [,<channel_list>]
:RESistance? [<range>[,<resolution>]], <channel_list>
:TEMPerature? <transducer>,<type> [,<channel_list>]
:VOLTage:AC? [<range> [,<resolution>]] [,<channel_list>]
:VOLTage[:DC]? [<range> [,<resolution>]] [,<channel_list>]
Make 4-wire ohms measurements.
Make 2-wire ohms measurements.
Make temperature measurements.
Make AC voltage measurements.
Make DC voltage measurements.
MEMory :VME:ADDRess <address>
:VME:ADDRess? [MIN | MAX]
:VME:SIZE <bytes>
:VME:SIZE? [MIN | MAX]
:VME:STATe <mode>
:VME:STATe?
Set address of memory on VME card.
Query VME memory location (address).
Amount of memory used on VME card.
Query amount of VME memory used.
Direct readings to VME memory card.
Query VME memory mode.
OUTPut :TTLTrg0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 [:STATe] OFF | 0 | ON | 1
:TTLTrg0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 [:STATe]?
Send voltmeter complete to VXIbus trigger lines.
Query voltmeter complete destination.
READ? Place multimeter in wait-for trigger state;
place readings in output buffer.
187 Command Reference Chapter 5