User`s manual

Programming Examples
The examples in this section demonstrate how to program the multimeter at
the register level. The programs follow the execution and timing models
covered in the previous section. The examples in this section include:
• Resetting the Multimeter
• Reading the ID Register
• Reading the Device Type Register
• Reading the Query Response Register
• Reading an Error Code
• Stand-Alone Multimeter Measurements
• Scanning Multimeter Measurements
System
Configuration
The HP BASIC/WS and C language example programs were developed
using the following system configurations:
HP BASIC/WS Programs Mainframe: HP 75000 Series C (HP E1401A)
Controller: HP V/382 (HP E1499B) w/HP E1481A drivers
and E1481L License to Use
Programming Language: HP BASIC/WS
Multimeter: HP E1411B (Logical address = 24)
Multiplexer: HP E1460A (Logical address = 25)
C Language Programs Mainframe: HP 75000 Series C (HP E1401A)
Controller: HP RADI-EPC7 486 Embedded Controller
w/Standard Instrument Control Library (SICL)
for DOS
Programming Language: C
Multimeter: HP E1411B (Logical address = 24)
Multiplexer: HP E1351A (Logical address = 25) w/HP E1403B
Adapter
220 HP E1326B/E1411B Multimeter Register-Based Programming Appendix C