Service manual

iprintf (dm, "TRIG SGL\n");
iscanf (dm, "%lf", &R[i]);
iscanf (dm, "%t", cr);
printf ("\nResistance of R%u = %lf", i+38, R[i]);
}
printf ("\n\n\nInstall Component Assembly and Test Fixture");
printf ("\n\n 1. Turn Mainframe AND 3458a DMM power OFF.");
printf ("\n 2. Connect HP-IB Cable between mainframe and DMM.");
printf ("\n 3. Install E1364A Component Assembly into Mainframe.");
printf ("\n 4. Attach Test Fixture to Component Assembly.");
printf ("\n 5. Turn Mainframe and DMM power ON");
printf ("\n 6. Press ENTER when ready to begin testing.");
getchar ();
/*...............Measure Channels 00-47 and 90-92 (HI, Lo, and G)...........*/
id = iopen(ADDR);
iprintf (id, "*RST\n");
iprintf (dm, "PRESET NORM;TRIG HOLD\n");
iprintf (dm, "END ALWAYS\n");
iprintf (dm, "FUNC OHMF\n");
j = 100;
printf ("\n\nChannel 00-47 and 90-92 HI measurements");
printf ("\n\n 1. Connect DMM Sense and Input HI leads to COMMON HI.");
printf ("\n 2. Connect DMM Sense and Input LO leads to VOLTAGE SENSE HI.");
printf ("\n 3. Press ENTER when connections are complete.");
getchar ();
for (i = 0;i <= 47; i++)
{
iprintf (id, "CLOS (@%u)\n", j+i);
iprintf (dm, "TRIG SGL\n");
iscanf (dm, "%lf", &value[i]);
iscanf (dm, "%t", cr);
iprintf (id, "OPEN (@%u)\n", j+i);
result[i] = value[i] - R[5];
if (result[i] < 0) result[i] = 0;
if (result[i] > 2.0) printf ("\n*** Resistance for Channel %u HI path is 2.0 Ohms
*** %lf", i, result[i]);
}
printf ("\n\nMeasurements complete for Channels 00-47 and 90-92 HI");
printf ("\nPress ENTER for Channels 90-92 LO measurements");
getchar ();
/*...........................Measure Channels 90-92 LO..................................*/
iprintf (id, "*RST\n");
printf ("\n\n\nChannels 90-92 LO measurements");
printf ("\n\n 1. Connect DMM Sense and Input HI leads to COMMON LO.");
printf ("\n 2. Connect DMM Sense and Input LO leads to VOLTAGE SENSE
LO.");
printf ("\n 3. Press ENTER when connections are complete.");
getchar ();
Appendix A Example C Programs 65