Manualshelf

Instruction manual

ManualsBrandsAgilent Technologies ManualsComputer equipmentE5071C
123456
Safety
Safety Summary
The following general safety precautions must be observed during all phases of
operation, service, and repair of this instrument. Failure to comply with these precautions
or with specific WARNINGS elsewhere in this manual may impair the protection provided
by the equipment. Such noncompliance would also violate safety standards of design,
manufacture, and intended use of the instrument. Agilent Technologies assumes no
liability for the customer's failure to comply with these precautions.
Notes;
The E5071C complies with INSTALLATION CATEGORY II as well as POLLUTION
DEGREE 2 in IEC61010-1. The E5071C is an INDOOR USE product.
The LEDs in the E5071C are Class 1 in accordance with IEC60825-1, CLASS 1
LEDPRODUCT
Ground the Instrument - To avoid electric shock, the instrument chassis and cabinet
must be grounded with the supplied power cable's grounding prong.
DO NOT Operate in an Explosive Atmosphere - Do not operate the instrument in the
presence of inflammable gasses or fumes. Operation of any electrical instrument in such an
environment clearly constitutes a safety hazard.
Keep Away from Live Circuits - Operators must not remove instrument covers.
Component replacement and internal adjustments must be made by qualified maintenance
personnel. Do not replace components with the power cable connected. Under certain
conditions, dangerous voltage levels may remain even after the power cable has been
disconnected. To avoid injuries, always disconnect the power and discharge circuits before
touching them.
DO NOT Service or Adjust the Instrument Alone - Do not attempt internal service or
adjustment unless another person, capable of rendering first aid and resuscitation, is
present.
Dangerous Procedure Warnings - Warnings, such as the example below, precede
potentially dangerous procedures throughout this manual. Instructions contained in the
warnings must be followed.
Dangerous voltage levels, capable of causing death, are present in this instrument.
Use extreme caution when handling, testing, and adjusting this instrument.
Safety Symbols
Instruction Manual symbol: the product is marked with this symbol
when it is necessary for the user to refer to the instrument manual.
Alternating current.