Installation guide

1-4 Agilent Technologies E5500B Installation Guide
Welcome to the E5500B Phase Noise Measurement System Series of
Solutions
System Requirements
The setup program in the E5500 Phase Noise Measurement Software makes
installation easy. In case you want a quick review of the system
requirements, we have listed them first.
The system requirements for the phase noise measurement software are:
• Pentium

microprocessor (100 MHz or higher recommended)
• 32 megabytes (MB) of memory (RAM)
• 1 gigabyte (GB) hard disk
• Super Video Graphics Array (SVGA)
• 2 additional 16-bit ISA slots available for the phase noise system
hardware.
❍ 1 for PC-Digitizer
❍ 1 for GPIB Interface Card
• Windows NT 4.0

• Windows NT 4.0 Service Pack 4 or greater
• IEEE-488 GPIB Interface Card (Agilent/HP 82341C GPIB Interface
Card)