Installation guide

1-6 Agilent Technologies E5500B Installation Guide
Welcome to the E5500B Phase Noise Measurement System Series of
Solutions
Step 2. Installing the Hardware
NOTE If you have ordered a preconfigured phase noise system from Agilent
Technologies, skip this step and proceed to “Step 9. Starting the
Measurement Software” on page 1-36.
Installing the phase noise hardware into your computer involves the
following steps:
“Step 2a - Removing your Computer’s Cover” on page 1-7
“Step 2b - Accessing your Computer’s ISA Slots” on page 1-8
“Step 2c - Taking ESD Precautions” on page 1-9
“Step 2d- Installing the Interface Cards” on page 1-10
“Step 2e - Replacing the Computer Cover” on page 1-13