Installation guide

Agilent Technologies E5500B Installation Guide 1-9
Welcome to the E5500B Phase Noise Measurement System Series of
Solutions
Step 2c - Taking ESD
Precautions
CAUTION To prevent possible ESD damage, you must be properly grounded with a
grounding wrist strap before touching the PC-Digitizer or GPIB (customer
supplied) Interface Cards. While inserting the cards, be sure to hold the cards
by their edges.
7. Using the disposable grounding strap, supplied with the PC-Digitizer
interface card, unwrap the first two folds of the wrist strap and wrap the
exposed adhesive side firmly around your wrist.
CAUTION Wear this grounding wrist strap before unpacking or touching the
PC-Digitizer or GPIB interface cards; it is provided for control of static
electricity. Failure to use the grounding wrist strap properly can result in
damage to electronic devices and assemblies
8. Unroll the rest of the wrist strap and peel the liner from the copper foil at
the opposite end.
9. Attach the copper foil to a convenient and exposed electrical ground
somewhere on the computer’s chassis. This should be an unpainted
surface of the computer cabinet.