Installation guide

1-16 Agilent Technologies E5500B Installation Guide
Welcome to the E5500B Phase Noise Measurement System Series of
Solutions
Step 3. Installing the I/O Libraries
NOTE If you have ordered a preconfigured phase noise system from Agilent
Technologies, skip this step and proceed to “Step 9. Starting the
Measurement Software” on page 1-36.
Installing the I/O libraries involves the following steps:
• Step 3a - Installing the Agilent/HP I/O Libraries,page1-16
• Step 3b - Installing the Agilent/HP I/O Library Upgrade,page1-17
NOTE If, for any reason, the Agilent/HP I/O libraries must be re-installed at a later
date, the E5500 Measurement software (Step 6.) must also be re-installed
after the I/O Library installation.
Step 3a - Installing the
Agilent/HP I/O
Libraries
1. Make sure your computer and monitor are turned on.
2. Place the E5500 Phase Noise Measurement Software CD-ROM in the
CD-ROM drive.
3. The following dialog box will appear.