Installation guide

Agilent Technologies E5500B Installation Guide 1-19
Welcome to the E5500B Phase Noise Measurement System Series of
Solutions
Step 4. Installing the PC-Digitizer Software
NOTE If you have ordered a preconfigured phase noise system from Agilent
Technologies, skip this step and proceed to “Step 9. Starting the
Measurement Software” on page 1-36.
1. Make sure your computer and monitor are turned on.
2. Place the E5500 Phase Noise Measurement Software CD-ROM in the
CD-ROM drive.
3. The following dialog box will appear.
4. Double-click on PC_Digitizer, then on Setup.exe and follow the
instructions (accept the default settings).
NOTE When offered the choice, do not restart your computer at this time.