Installation guide

Agilent Technologies E5500B Installation Guide 1-23
Welcome to the E5500B Phase Noise Measurement System Series of
Solutions
Step 7. Using the Asset Manager to Configure
your System
The following procedure will configure both the Agilent/HP 70420A Phase
Noise Test Set and PC-Digitizer so they can be used in the E5500A Phase
Noise Measurement System to make measurements.
NOTE If you have ordered a preconfigured phase noise system from Agilent
Technologies, skip this step and proceed to “Step 9. Starting the
Measurement Software” on page 1-36.
1. Make sure your computer and monitor are turned on.
2. Place the E5500 Phase Noise Measurement Software CD-ROM in the
CD-ROM drive.
3. Click the Start button, point to Programs, point to Agilent
Subsystems, point to E5500 Phase Noise, and then click E5500 Asset
Manager.