Installation guide

Agilent Technologies E5500B Installation Guide 1-25
Welcome to the E5500B Phase Noise Measurement System Series of
Solutions
7. From the Asset Type pull-down list, select Test Set, then click the Next
button.
8. Click on Agilent/HP 70420, then click the Next button.
9. From the Interface pull-down list, select GPIB0.
10. In the Address box, type 20. 20 is the default address for the Agilent/HP
70420A phase noise test set. For a list of default addreseses, refer to
Table 1-3 on page 1-32.
The Library pull-down list does not apply to this example. It applies
specifically to either the Agilent Technologies GPIB or the National
GPIB interface cards.