Installation guide

Agilent Technologies E5500B Installation Guide 1-33
Welcome to the E5500B Phase Noise Measurement System Series of
Solutions
Step 8. Entering the License Key for the Phase
Noise Test Set
Use the following procedure to enter your keyword for your Agilent/HP
70420A Phase Noise Test Set.
NOTE If you have ordered a preconfigured phase noise system from Agilent
Technologies, skip this step and proceed to “Step 9. Starting the
Measurement Software” on page 1-36.
1. Make sure your computer and monitor are turned on.
2. Click the Start button, point to Programs, point to Agilent
Subsystems, point to E5500 Phase Noise, and then click E5500 Asset
Manager.