Installation guide

Agilent Technologies E5500B Installation Guide 1-41
Welcome to the E5500B Phase Noise Measurement System Series of
Solutions
Beginning the
Measurement
1. From the Measure menu, choose New Measurement.
2. When the Do you want to perform a New Calibration and
Measurement dialog box appears, click OK.
3. When the Connect Diagram dialog box appears, connect the 50
Ω
termination provided with your system to the Agilent/HP 70420A Test
Set’s Noise Input connector. (See Figure 1-1.)
Since the System Confidence Test tests the Agilent/HP 70420A Test
Set’s low noise amplifier the following connect diagram does not apply.
Figure 1-1 System Confidence Test Connection Diagram.
50
Ω
termination
goes here.