Installation guide

1-42 Agilent Technologies E5500B Installation Guide
Welcome to the E5500B Phase Noise Measurement System Series of
Solutions
Making the
Measurement
1. Press the Continue key. Because you selected New Measurement to
begin this measurement, the System starts by running the routines
required to calibrate the current measurement setup.
Figure 1-2 shows a typical baseband phase noise plot for an Agilent/HP
70420A Phase Noise Test Set.
Figure 1-2 Typical Phase Noise Curve for a System Confidence Test.
Congratulations You have completed a phase noise measurement. You will find that this
measurement of the Agilent/HP 70420A Phase Noise Test Set’s low noise
amplifier circuitry provides a convenient way to verify that the System
hardware and software are properly configured for making noise
measurements.