User`s guide

Preparing for Imaging 4
Agilent 5500 SPM User’s Guide 66
Figure 39 Holding the tweezers as shown, remove a probe from the
protective case
5 With your free hand, use the spring key to rock back the retainer
spring (Figure 40).
6 Place the probe between the guides such that a little more than half
of the probe extends over the lens (placement will vary depending on
the type and shape of the probe). Figure 40 shows this process. The
final probe position should be as shown in Figure 38 on page 65.
Figure 40 Hold back the retaining spring while placing the probe
7 Gently lower the spring clip to hold the probe in place.